I'm working on together my water cooling system for my Storm Scout case, and have decided to go with a RX120 radiator mounted on the bottom between the PSU and the HD cage. i plan on have the rad in the case, with a low speed fan blowing out the bottom (either on top pushing or under it pulling if theres any difference), and i'm wondering how much clearance under the case i should have to allow the fan to properly blow air out the bottom. From the factory there is about 4.7mm of clearance under the case. Also, as noted in Rodney's Review of this case, i'd like to some something other than just hard plastic feet to protect my desktop and cut down on some noise. So, thoughts on the height increase and either a push or pull setup for the radiator.